Hot rodding the HEI distributor
m (Fix link) |
m (→Mechanical, aka "centrifugal" advance: Add template) |
||
| Line 163: | Line 163: | ||
The mechanical advance should be "all in" by about 2800-3200 RPM for a typical street performance motor (additional advance above this RPM point is neither needed or wanted; increased turbulence in the combustion chamber offsets the need for further ignition advance beyond this RPM level). This is adjusted by changing the centrifugal advance weights and/or springs to tailor the rate. | The mechanical advance should be "all in" by about 2800-3200 RPM for a typical street performance motor (additional advance above this RPM point is neither needed or wanted; increased turbulence in the combustion chamber offsets the need for further ignition advance beyond this RPM level). This is adjusted by changing the centrifugal advance weights and/or springs to tailor the rate. | ||
| − | + | {{Note1}} In almost every case, using the advance kit-supplied weights and cam will not work as well as using the stock weights and cam along with the different springs. | |
If you use the [http://www.summitracing.com/parts/CRN-99600-1 Crane advance kit], a starting point is to install one blue (heavy) spring and one silver (medium) spring, or two medium springs. The springs are located directly under the rotor and are easy to remove/replace by hand or with needle-nose pliers or hemostats. Use these springs to give you an advance curve that starts at about 800 RPM and ends at 2800-3200 RPM. | If you use the [http://www.summitracing.com/parts/CRN-99600-1 Crane advance kit], a starting point is to install one blue (heavy) spring and one silver (medium) spring, or two medium springs. The springs are located directly under the rotor and are easy to remove/replace by hand or with needle-nose pliers or hemostats. Use these springs to give you an advance curve that starts at about 800 RPM and ends at 2800-3200 RPM. | ||
Your Privacy Choices