Driveshafts: Swap solutions
m (moved Swap Solutions: Driveshafts to Driveshafts: Swap solutions) |
m (reset index) |
||
| Line 35: | Line 35: | ||
Bolt the rear joint onto the pinion. Slide the front yoke onto the transmission output shaft until it bottoms and will go no further. Now, pull the yoke out 5/8" to 3/4". Measure between the centerlines of the bearing cups on the front and rear joints. This will be the measurement you will give your shop to make your new driveshaft. Give them the front and rear joints and the measurement and they'll make and balance a shaft for you. If you want it to be bulletproof, specify that you want it built with 0.093" tubing. Should you opt for a larger diameter driveshaft, be sure it will clear the floorboards, etc. at full rear end compression. | Bolt the rear joint onto the pinion. Slide the front yoke onto the transmission output shaft until it bottoms and will go no further. Now, pull the yoke out 5/8" to 3/4". Measure between the centerlines of the bearing cups on the front and rear joints. This will be the measurement you will give your shop to make your new driveshaft. Give them the front and rear joints and the measurement and they'll make and balance a shaft for you. If you want it to be bulletproof, specify that you want it built with 0.093" tubing. Should you opt for a larger diameter driveshaft, be sure it will clear the floorboards, etc. at full rear end compression. | ||
| − | |||
| − | |||
| − | |||
Your Privacy Choices