Exhaust manifold
From Crankshaft Coalition Wiki
m (→Rams horn) |
m (→Gaskets) |
||
| Line 24: | Line 24: | ||
Regardless of what gasket that is used, trim the ID to fit the largest port, be it the header or the head port so there's no overhang into the port. After trimming, start all the bolts and just drop the gaskets into place. Other header gaskets can have the bolt holes slotted in the same way as the foil backed gaskets shown above, for easier installation. | Regardless of what gasket that is used, trim the ID to fit the largest port, be it the header or the head port so there's no overhang into the port. After trimming, start all the bolts and just drop the gaskets into place. Other header gaskets can have the bolt holes slotted in the same way as the foil backed gaskets shown above, for easier installation. | ||
| + | |||
| + | Use antiseize compound on the bolts and retighten after each heat cycle until they take a set. | ||
==Ford manifolds== | ==Ford manifolds== | ||
Your Privacy Choices