Make a fiberglass fan shroud
(→Finishing the part) |
(→Finishing the part) |
||
| Line 196: | Line 196: | ||
As this is a one off fan shroud, special fairing techniques are not employed in it's exicution. A DA sander with 80 grit is used in all accessable areas, and hand sanding in the corners is done with 80 grit as well. | As this is a one off fan shroud, special fairing techniques are not employed in it's exicution. A DA sander with 80 grit is used in all accessable areas, and hand sanding in the corners is done with 80 grit as well. | ||
[[Image:47skim coat of bondo.JPG|center|600px]] | [[Image:47skim coat of bondo.JPG|center|600px]] | ||
| − | |||
| − | |||
Some areas needed another coat to level the surface. | Some areas needed another coat to level the surface. | ||
| + | |||
| + | [[Image:48more bondo.JPG|center|600px]] | ||
Your Privacy Choices