Make a fiberglass fan shroud
(→Measurement and analysis) |
(→Shaping and gluing the foam) |
||
| Line 34: | Line 34: | ||
===Shaping and gluing the foam=== | ===Shaping and gluing the foam=== | ||
| − | Cut foam to shape with a handsaw, putty knife, or bandsaw. Then, fit and glue pieces of foam larger than your layout on the board. A hot melt glue gun makes gluing this foam fast and easy. You can also glue the foam down with an expanding urethane glue, such as Gorilla glue, or some of the expanding foam that comes in an aerosol can. The different glues can make sanding over seam lines difficult, as they are usually a different density and hardness than the surrounding foam. | + | Cut foam to shape with a handsaw, putty knife, or bandsaw. Then, fit and glue pieces of foam larger than your layout on the board. A hot melt glue gun makes gluing this foam fast and easy. You can also glue the foam down with an expanding urethane glue, such as [http://www.gorillaglue.com/home.htm Gorilla glue], or some of the expanding foam that comes in an aerosol can. The different glues can make sanding over seam lines difficult, as they are usually a different density and hardness than the surrounding foam. |
Shaping this foam also can be done with sandpaper, sureform files, knives, and picks. Even your fingers can shape this foam quite easily and rapidly. | Shaping this foam also can be done with sandpaper, sureform files, knives, and picks. Even your fingers can shape this foam quite easily and rapidly. | ||
Your Privacy Choices