Crankshaft Coalition Wiki
(→Articles to work on) |
|||
| Line 1: | Line 1: | ||
__NOTOC__ | __NOTOC__ | ||
| − | Welcome to the Crankshaft Coalition Wiki, a free hotrodding encyclopedia created by hotrodders. On the Crankshaft Coalition Wiki, you can read and write hotrodding articles, just as easily as you can read and write posts on a web forum | + | Welcome to the Crankshaft Coalition Wiki, a free hotrodding encyclopedia created by hotrodders. On the Crankshaft Coalition Wiki, you can read and write hotrodding articles, just as easily as you can read and write posts on a web forum. Join us as we create the net's first free hotrodding encyclopedia. |
For more info, check out the [[8 sentence quick-start guide]]. For further details, see [[Help:Contents]]. | For more info, check out the [[8 sentence quick-start guide]]. For further details, see [[Help:Contents]]. | ||
| − | == | + | ==New articles== |
| + | |||
| + | |||
| + | |||
| + | |||
| + | ==Good articles== | ||
===[[Straightening a rear end housing]]=== | ===[[Straightening a rear end housing]]=== | ||
This article describes how to build an inexpensive table for accurately straightening rear end housings. The table is built from an old gas cylinder cart, an I-beam, and common jackstands. Full article: [[Straightening a rear end housing]]. | This article describes how to build an inexpensive table for accurately straightening rear end housings. The table is built from an old gas cylinder cart, an I-beam, and common jackstands. Full article: [[Straightening a rear end housing]]. | ||
| Line 26: | Line 31: | ||
|[[Image:complete_steering_joint_assembly_with_Heim_joint_mounted.jpg|thumb|left|The finished steering shaft assembly.]] | |[[Image:complete_steering_joint_assembly_with_Heim_joint_mounted.jpg|thumb|left|The finished steering shaft assembly.]] | ||
|} | |} | ||
| − | |||
| − | |||
| − | |||
*[[Body and exterior tips]] | *[[Body and exterior tips]] | ||
| Line 47: | Line 49: | ||
==Articles to work on== | ==Articles to work on== | ||
These articles are off to a good start, but still need considerable work. Specifically, they could use more information, photos, and general cleanup and organizing. | These articles are off to a good start, but still need considerable work. Specifically, they could use more information, photos, and general cleanup and organizing. | ||
| − | |||
*[[How to rebuild automotive carburetors]] | *[[How to rebuild automotive carburetors]] | ||
| Line 67: | Line 68: | ||
*[[Swapping to rack and pinion steering]] | *[[Swapping to rack and pinion steering]] | ||
*[[Cold air intakes]] | *[[Cold air intakes]] | ||
| + | |||
| + | ==Photos needed== | ||
| + | We need the following photos to add to articles. Please [[Special:Upload|upload them]] if you have them. | ||
| + | *[[Epoxy primer]] needs a photo of some cans of epoxy primer and hardener. | ||
| + | *[[Chrysler Hemi engine]] needs a photo of an early Hemi engine, a 426 Hemi engine, and an early Hemi engine on an engine stand (or otherwise being "rebuilt"). | ||
| + | *[[Homologation]] needs a photo af either a 426 Hemi engine, a 1964 Pontiac GTO, or any "Police" parts. | ||
==Start a new article== | ==Start a new article== | ||
Your Privacy Choices