Head gasket
(→When replacing a blown head gasket) |
(→When replacing a blown head gasket) |
||
| Line 51: | Line 51: | ||
==When replacing a blown head gasket== | ==When replacing a blown head gasket== | ||
*Check to make sure the heads and block are straight. If they're warped, you could easily end up with another blown head gasket. This can be done with a straight edge and a feeler gauge. This is also a good time to check for cracks. | *Check to make sure the heads and block are straight. If they're warped, you could easily end up with another blown head gasket. This can be done with a straight edge and a feeler gauge. This is also a good time to check for cracks. | ||
| − | *Prep the surface (more info on this). | + | *Prep the surface (more info on this). Mating surfaces should be smooth, clean, and dry. |
*Chase the bolt and stud holes. Clean with compressed air. | *Chase the bolt and stud holes. Clean with compressed air. | ||
*Pre-fit the head gasket. | *Pre-fit the head gasket. | ||
Your Privacy Choices