Talk:Removing stuck fasteners
(oralnot) |
m (Reverted edits by 202.84.17.42 (Talk); changed back to last version by 74.33.97.133) |
||
| Line 1: | Line 1: | ||
| − | |||
Welding a nut onto a broken bolt, flush with the casting or whatever tends to make for a poor weld. As a blacksmith for 55 years, I always found it much better to weld on a clean uncoated flat washer. Use higher welding 'heat' to expand and break down rust, etc. Then try a large pliers or smaller pipe wrench. Or, weld a larger nut onto the washer, which will allow better and stronger welding. Always let cool to room temp BEFORE attemping any removel of bolt. | Welding a nut onto a broken bolt, flush with the casting or whatever tends to make for a poor weld. As a blacksmith for 55 years, I always found it much better to weld on a clean uncoated flat washer. Use higher welding 'heat' to expand and break down rust, etc. Then try a large pliers or smaller pipe wrench. Or, weld a larger nut onto the washer, which will allow better and stronger welding. Always let cool to room temp BEFORE attemping any removel of bolt. | ||
Your Privacy Choices