Straightening a rear end housing
m (Reverted edits by 218.84.186.230 (Talk); changed back to last version by Jon) |
(→Related information) |
||
| Line 43: | Line 43: | ||
In this case, when the tube cooled, the housing end was only a few thousandths of an inch off, and was easily bent into alignment cold, using only the bottle jack. This housing was initially out by almost 1/4" on one side, and 3/16" on the other. Now, the housing end slips on with minimal effort. | In this case, when the tube cooled, the housing end was only a few thousandths of an inch off, and was easily bent into alignment cold, using only the bottle jack. This housing was initially out by almost 1/4" on one side, and 3/16" on the other. Now, the housing end slips on with minimal effort. | ||
[[Image:Insert_fits_properly.jpg|frame|none|The housing end slips on with minimal effort.]] | [[Image:Insert_fits_properly.jpg|frame|none|The housing end slips on with minimal effort.]] | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
Your Privacy Choices